#Singularity computers spectre full#

The PowerBoard has integrated capacitors for noise and ripple, and includes both ARGB and UV LEDs with a switch to use both at the same time, or one or the other. The layout has been changed to improve connector locations, and three direct connect SATA 2.5” drive positions have been added which are accessible from the back of the distribution plate. The PowerBoard has been redesigned for increased power delivery with all choke points removed. The distribution plate is a new design with triple layers throughout all fluid routes for improved flow and aesthetics. The two on top of the PSU shroud cannot be used with vertically mounted GPUs.The next generation of Spectre has arrived in the form of a Cyberpunk themed limited edition. Two are on the top of the PSU shroud, four inside of the PSU shroud and there is one integrated on the PowerBoard. Spectre Integra-M has 7x 2.5” Drive positions. The radiator mounting panels have a large range of adjustment to help with port alignment to the distribution plate. The PowerBoard can handle the most high-end PSUs and components. For the water-cooling system it can fit 2x 360mm radiators 45mm thick with a single set of fans and the D5 pump. It is designed to fit the largest high-end GPUs. Spectre 3.0 Integra M fits ATX motherboards and has 7 expansion slots. The fill port is at the highest point on the back for the case and the drain point at the lowest point. The reservoir was designed to remove air as quickly as possible making the loop easier to fill. The pump top was designed for the D5 pump, maximizing flow to and from the distribution plate. The integrated loop routes in Spectre Integra-M allow for more flow than 16mm tubes. This meant that we could focus more on optimization than would normally be possible. Integration & Optimization With the integration we did not just develop a case, we also developed all the integrated components. No cable management for the core component cables thanks to the PowerBoard integration. Reduced build time due to integration With the pump, reservoir, fill and drain ports, parts of the water-cooling loop, the core component cables, PWM and ARGB hubs all integrated there is less assembly to be done. Spectre 3.0 Integra-M comes included with a standard set of black sleeved linking cables including 24pin x1, 8pin EPS x2, 8pin PCIE x3 meaning that these cables don’t have to be purchased separately. It is a new method for cables allowing standardization of cable lengths and making cable management almost unnecessary. Essentially the PowerBoard is a distribution plate for cables also integrating other features and functions. The LEDs can be switched on or off and you can switch between ARGB or UV or have both on at the same time. The PowerBoard has x24 ARGB and UV LEDs positioned around the external and internal perimeter to optimally light up the distribution plate. The Spectre Integra-M PowerBoard also has an integrated touch sensing Power Button. PowerBoard Integration The PowerBoard is a PCB integrating 24pin, EPS, PCIE and 12VHPWR along with PWM and ARGB Hubs, SATA and Power and Reset Buttons. A completely new take on computer cables and cable management. Powerboard It has a fully integrated solution/replacement for cables with the Singularity Computers PowerBoardĬable Management Introducing the invoative PowerBoard. Custom colored sleeved linking cables can be purchased separately. Black sleeved linking cables are included with the case. There is no rear access needed to the case for cable management, all cables can be connected from the front and little to no cable management is needed. It has built in filter capacitors, 24 integrated ARGB and UV LEDs facing inwards and outwards, integrated direct connect SATA, power, and reset buttons, and a touch activated power button. The PowerBoard supports the most high-end components and includes two of the new 12VHPWR connectors along with x3 8pin PCIE connectors.

This means that both have become far more streamlined, meaning more features and compatibility. Previously we have created PowerBoards for existing cases, but for Integra-M we have developed the PowerBoard and case together. It has a fully integrated solution for cables with the Singularity Computers PowerBoard. Integra-M has a large part of the water-cooling loop integrated with a completely new distribution plate design. Integra-M is 25% smaller than Spectre 3.0 (all versions) but maintains all the features, except that it fits ATX motherboards and two 360mm radiators which are 40mm thick.

#Singularity computers spectre full#

It is a full re-design using everything we have learned from the development of Spectre which has continued since 2015.

Spectre 3.0 Integra-M is a more compact ATX version of Spectre.